Investigation of the Corrosion Behavior of Selected Metal Electrodes used in a Microbial Fuel Cell for Clean Energy Production

Authors

  • Mohammed K. Fayyadh Department of Energy Engineering, The Graduate School of Natural and Applied Sciences, Ankara University, Ankara - Turkey.
  • Özcan Köysüren Department of Energy Engineering, The Graduate School of Natural and Applied Sciences, Ankara University, Ankara - Turkey.
  • Basim O. Hasan Department of Chemical Eng., Al-Nahrain University, Baghdad - Iraq.

DOI:

https://doi.org/10.29194/NJES.28010013

Keywords:

Microbial Fuel Cell, Electrode Material, Corrosion, Microorganism, Agitation Velocity, Aeration

Abstract

The electrodes material plays an important role in the amount of electricity produced in microbial fuel cells (MFCs). Metal electrodes used in MFCs are subject to biological and concentration cell corrosion which leads to a decrease in the cell efficiency. In the present work, the corrosion behavior of three selected electrode materials, namely, stainless steel, copper, and zinc under different operating conditions was investigated and discussed. In anode chamber, the microorganism (MO) used was Saccharomyces cerevisiae (yeast) with sodium acetate as a substrate forming the microbial corrosive solution. In the cathode chamber, the corrosive solution is aerated water. The effects of different operating parameters on the corrosion rate (CR) of these electrodes were studied such as: microorganism concentration, aeration of cathode chamber, and flow velocity in cathode chamber. The potential of the each electrode was measured to understand the corrosion behavior of electrodes and the produced current was also investigated. It was found that the corrosion rate of the electrodes in both anode and cathode chambers increases with increasing MO concentration in anode chamber and with increasing agitation speed in cathode chamber. The bio-corrosion is an important part of the corrosion occurring in microorganism chamber. The stainless steel exhibited the lowest corrosion rate for the whole investigated range of operating parameters followed by copper. The zinc electrode was found to be poor as an electrode in MFC as its corrosion rate was very high in all conditions investigated. In addition, this study showed that the air pumping in water chamber causes an appreciable increase in the corrosion rate in both chambers and an increase in the produced current.

Downloads

Download data is not yet available.

References

M. Zhou, J. Yang, H. Wang, T. Jin, D. J. Hassett, and T. Gu, "Bioelectrochemistry of microbial fuel cells and their potential applications in bioenergy," Bioenergy Research: Advances and Applications, pp. 131–152, 2014. DOI: https://doi.org/10.1016/B978-0-444-59561-4.00009-7

A. Rhoads, H. Beyenal, and Z. Lewandowski, "Microbial fuel cell using anaerobic respiration as an anodic reaction and biomineralized manganese as a cathodic reactant," Environmental Science & Technology, vol. 39, no. 12, pp. 4666–4671, 2005. DOI: https://doi.org/10.1021/es048386r

R. F. Jack, D. B. Ringelberg, and D. C. White, "Differential corrosion rates of carbon steel by combinations of Bacillus sp., Hafnia alvei, and Desulfovibrio gigas established by phospholipid analysis of electrode biofilm," Corrosion Science, vol. 33, pp. 1843–1853, 1992. DOI: https://doi.org/10.1016/0010-938X(92)90188-9

B. Little and P. Wagner, "Indicators for sulfate-reducing bacterium microbiologically influenced corrosion," in Biofouling and Biocorrosion in Industrial Water Systems, G. G. Geesey, Z. Lewandowski, and H. C. Flemming, Eds., 2nd ed. CRC Press Inc., Boca Raton, FL, 1994, pp. 213–230.

K. M. Usher, A. H. Kaksonen, I. Cole, and D. Marney, "Critical review: microbially influenced corrosion of buried carbon steel pipes," International Biodeterioration & Biodegradation, vol. 93, pp. 84–106, 2014. DOI: https://doi.org/10.1016/j.ibiod.2014.05.007

M. Mashkour and M. Rahimnejad, "Effect of various carbon-based cathode electrodes on the performance of microbial fuel cell," Biofuel Research Journal, vol. 2, no. 4, pp. 296–300, 2015. DOI: https://doi.org/10.18331/BRJ2015.2.4.3

Ç. E. K. Nurettin, "Examination of zinc electrode performance in microbial fuel cells," Gazi University Journal of Science, vol. 30, no. 4, pp. 395–402, 2017.

Li . Z., J. Zhang . J. Cheng, The Influence of Critical Flow Velocity on Corrosion of Stainless Steel, J Fail. Anal. and Preven. (2017) 17:1234–1240 DOI: https://doi.org/10.1007/s11668-017-0369-1

X. Zhu and E. Logan, "Copper anode corrosion affects power generation in microbial fuel cells," Journal of Chemical Technology & Biotechnology, Jun. 2013. DOI: https://doi.org/10.1002/jctb.4156

E. Guerrini et al., "Electrochemical behavior of stainless steel anodes in membraneless microbial fuel cells," Journal of The Electrochemical Society, vol. 161, no. 3, pp. H62–H67, 2014. DOI: https://doi.org/10.1149/2.096401jes

F. Bensalah et al., "Carbon Nano-Fiber/PDMS composite used as corrosion-resistant coating for copper anodes in microbial fuel cells," Nanomaterials, vol. 11, p. 3144, 2021. DOI: https://doi.org/10.3390/nano11113144

W. P. Iverson, "Microbial corrosion of metals," Advances in Applied Microbiology, vol. 32, pp. 1–36, 1987. DOI: https://doi.org/10.1016/S0065-2164(08)70077-7

M. S. Khan et al., "Microbiologically influenced corrosion mechanism of ferrous alloys in marine environment," Metals, MDPI, Aug. 2022. DOI: https://doi.org/10.3390/met12091458

V. Cicek, Corrosion Engineering, 1st ed. Scrivener Publishing, Wiley, 2017.

M. M. Ali and B. O. Hasan, "Galvanic corrosion of carbon steel under concentration cell formation in MgCl2 solution as an inorganic pollutant and the effect of flow velocity," Corrosion Reviews, vol. 38, no. 3, pp. 287–298, 2020. DOI: https://doi.org/10.1515/corrrev-2019-0092

A. Al-Bahir, "Estimation of the performances of creatine and creatinine as eco-friendly corrosion inhibitors for copper in sodium hydroxide solution," International Journal of Electrochemical Science, vol. 18, p. 100040, 2023. DOI: https://doi.org/10.1016/j.ijoes.2023.100040

R. Risheek, J. Aneesh, N. Gobinath, and R. Radha, "Investigation on corrosion inhibitors for zinc batteries: sodium sulphate," Materials Today: Proceedings, Mar. 2023. DOI: https://doi.org/10.1016/j.matpr.2023.03.108

V. C. Kalia and P. Kumar, Microbial Applications: Bioremediation and Bioenergy. Springer, 2017. DOI: https://doi.org/10.1007/978-3-319-52666-9

M. S. Hamed, H. S. Majdi, and B. O. Hasan, "Effect of electrode material and hydrodynamics on the produced current in double chamber microbial fuel cells," ACS Omega, vol. 5, no. 18, pp. 10339–10348, 2020. DOI: https://doi.org/10.1021/acsomega.9b04451

M. F. Hamad et al., "The local dependence of bubble breakup for different impeller geometries in a stirred tank," Iranian Journal of Science and Technology, Transactions of Mechanical Engineering, vol. 47, no. 2, 2023. DOI: https://doi.org/10.1007/s40997-022-00547-4

M. T. Montañés, R. Sánchez-Tovar, J. García-Antón, and V. Pérez-Herranz, "The influence of Reynolds number on the galvanic corrosion of the copper/AISI 304 pair in aqueous LiBr solutions," Corrosion Science, vol. 51, no. 11, pp. 2733–2742, Nov. 2009. DOI: https://doi.org/10.1016/j.corsci.2009.07.003

Z. Li and J. Zhang, "The influence of flow velocity on electrochemical reaction of metal surface," IOP Conf. Series: Materials Science and Engineering, vol. 274, 2017. DOI: https://doi.org/10.1088/1757-899X/274/1/012098

G. Li et al., "Effect of hydrogen on pitting corrosion of 2205 duplex stainless steel under alternating dry/wet marine environment," International Journal of Hydrogen Energy, Feb. 2023. DOI: https://doi.org/10.1016/j.ijhydene.2023.01.210

B. O. Hasan, "Galvanic corrosion of carbon steel–brass couple in chloride containing water and the effect of different parameters," Journal of Petroleum Science and Engineering, vol. 24, pp. 137–145, 2014. DOI: https://doi.org/10.1016/j.petrol.2014.09.036

Downloads

Published

07-04-2025

How to Cite

[1]
M. Fayyadh, Özcan Köysüren, and B. O. Hasan, “Investigation of the Corrosion Behavior of Selected Metal Electrodes used in a Microbial Fuel Cell for Clean Energy Production”, NJES, vol. 28, no. 1, pp. 13–20, Apr. 2025, doi: 10.29194/NJES.28010013.

Similar Articles

1-10 of 123

You may also start an advanced similarity search for this article.