Object Dimension Inspection Utilizing 3D Laser Scanner

Authors

  • Mohammed Z. Al-Faiz, College of Eng./Nahrain University
  • Omar M. Salih College of Eng./Nahrain University

Keywords:

3D laser scanning, dimension, decision making

Abstract

In this paper, the processes of 3D LASER scanning and dimension inspection were simulated for certain dimensions object. The scanning operation is divided into two major modes, Searching Mode and Scanning Mode. In scanning mode two sub-processes (scanned point validation and plane fitting) are introduced, i.e. to find the plane which contains most of scanned points. The final step is the decision making, which gives a decision about acceptance or rejection of the

scanned manufactured object. The proposed algorithm is successfully applied to seven cases. One of them which has the exact dimensions and

this case has been accepted. The other six cases, which have different dimensions, have been rejected.

Downloads

Download data is not yet available.

Downloads

Published

20-12-2018

Issue

Vol. 11 No. 3 (2008): Al-Nahrain University, College of Engineering Journal (NUCEJ)

Section

Articles

License

The authors retain the copyright of their manuscript by submitting the work to this journal, and all open access articles are distributed under the terms of the Creative Commons Attribution-NonCommercial 4.0 International (CC-BY-NC 4.0), which permits use for any non-commercial purpose, distribution, and reproduction in any medium, provided that the original work is properly cited.

How to Cite

[1]
M. Z. Al-Faiz, and O. M. Salih, “Object Dimension Inspection Utilizing 3D Laser Scanner”, NJES, vol. 11, no. 3, pp. 494–500, Dec. 2018, Accessed: Nov. 25, 2024. [Online]. Available: https://nahje.com/index.php/main/article/view/550