Numerical Simulation of Performance Enhancement of Solar Vortex Engine
DOI:
https://doi.org/10.29194/NJES.27010046Keywords:
Solar Vortex Engine, Performance Enhancement, Vertical Twisted Blade, Updraft Airflow, Artificial VortexAbstract
The solar vortex engine (SVE) has been investigated to generate power using renewable energy. The SVE was constructed from a vortex generation engine (VGE) and solar air collector (SAC). The SVE system primarily utilizes vertical air movement. However, the airflow entering the VGE experiences an obstruction. The purpose of this paper is to propose a new design for the VGE that creates a swirling updraft capable of overcoming air obstruction and reducing energy losses. A 3D numerical model of VGE was developed to visualize vortex generation. The modeling of the VGE is carried using SOLIDWORKS software and ANSYS-FLUENT 18. The improved VGE has six vertical twisted convergence blades connected to six guide vanes to direct updraft air in an anticlockwise swirl. All blades and vanes are housed in a VGE cylinder with a diameter of 20cm and a height of 30cm. The simulation results were validated by comparing with the results obtained from the present experimental model. The simulation results match with a mean difference of less than 5% with the experimental measurements. The results of the current CFD investigation indicate that there is a gradient in air temperature and pressure within the VGE, ranging from the highest values of 314 K and 3.85 Pa to the lowest values of 308 K and 2.42 Pa, respectively. The CFD visualization shows a threefold increase in axial velocity and a fivefold increase in tangential velocity within an artificial vortex. Therefore, it can be concluded that the new VGE construction is highly efficient in generating a vortex.
Downloads
References
Ayad Tareq Mustafa, “Performance Evaluation of a Developed Solar Vortex Engine”, Ph.D. Thesis, Mechanical Engineering Department, University Technology PETRONAS, Perak, Malaysia, 2016. http://utpedia.utp.edu.my/id/eprint/25169/
L. Michaud, "Heat to work conversion during upward heat convection Part I: Carnot engine method," Atmospheric research, vol. 39, pp. 157-178, 1995. DOI:10.1016/0169-8095(95)00010-O
L. Michaud, "Heat to work conversion during upward heat convection Part II: Internally generated entropy method," Atmospheric research, vol. 41, pp. 93-108, 1996. DOI:10.1016/0169-8095(95)00073-9
N. O. Renno, "A thermodynamically general theory for convective vortices", Tellus A, vol. 60, pp. 688-699, 2008. https://www.tandfonline.com/doi/abs/10.1111/j.1600-0870.2007.00331.x
N. O. Rennó and H. B. Bluestein, "A simple theory for waterspouts", Journal of the atmospheric sciences, vol. 58, pp. 927-932, 2001.
A. M. Makarieva, V. G. Gorshkov, and A. V. Nefiodov, "Condensational theory of stationary tornadoes", Physics Letters A, vol. 375, pp. 2259-2261, 2011. DOI:10.1016/j.physleta.2011.04.023
N. Ninic and S. Nizetic, "Elementary theory of stationary vortex columns for solar chimney power plants," Solar energy, vol. 83, pp. 462-476, 2009. DOI: 10.1016/j.solener.2008.09.002
A. Koonsrisuk and T. Chitsomboon, "Mathematical modeling of solar chimney power plants," Energy, vol. 51, pp. 314-322, 2013. DOI: 10.1016/j.energy.2012.10.038
M. d. S. Bernardes, A. Voß, and G. Weinrebe, "Thermal and technical analyses of solar chimneys," Solar Energy, vol. 75, pp. 511-524, 2003. DOI: 10.1016/j.solener.2003.09.012
J.-y. Li, P.-h. Guo, and Y. Wang, "Effects of collector radius and chimney height on power output of a solar chimney power plant with turbines," Renewable Energy, vol. 47, pp. 21-28, 2012. DOI: 10.1016/j.renene.2012.03.018
R. Sangi, "Performance evaluation of solar chimney power plants in Iran", Renewable and Sustainable Energy Reviews, vol. 16, pp. 704-710, 2012. DOI:10.1016/j.rser.2011.08.035
N. Pasumarthi and S. Sherif, "Experimental and theoretical performance of a demonstration solar chimney model—Part I: mathematical model development," International Journal of Energy Research, vol. 22, pp. 277-288, 1998. DOI: 10.1016/S0140-6701(98)96631-0
Mustafa T. Mustafa and Ayad T. Mustafa, “Numerical Simulation of Thermal-Hydrodynamic Behavior within Solar Air Collector”, Journal of Engineering, Vol. 24, No. 3, 2018.
Mohammed A. Neama and Ayad T. Mustafa, “Experimental Investigation and Evaluation of Inclined Solar Air Heater”, Journal of Engineering and Applied Sciences, Vol.14, pp: 10291-10297, 2019. DOI: 10.36478/jeasci.2019.10291.10297
Mohammed A. Neama and Ayad T. Mustafa, “Thermal behavior of natural convection flow in an inclined solar air heater”, Journal of Mechanical Engineering and Sciences, Vol. 14, Issue 4, pp. 7569 – 7588, 2020. DOI: 10.15282/jmes.14.4.2020.22.0596
Ayad T. Mustafa and Mohammed A. Neama, “Natural convection heat transfer on an inclined unglazed solar absorber-plate: Experimental investigation”, AIP Conference Proceedings 2530, 090002, 2023. DOI:10.1063/5.0121075
Ayad T. Mustafa, Hussain H. Al-Kayiem, Syed Ihtsham U. Gilani, “Investigation and Evaluation of the Solar Air Collector Model to Support the Solar Vortex Engine”, ARPN Journal of Engineering and Applied Sciences, Vol. 10, No. 12, 2015.
Hussain H. Al-Kayiem, Ayad T. Mustafa, Syed I. U. Gilani, “Solar vortex engine: Experimental modelling and evaluation”, Renewable Energy, Vol. 121, pp. 389-399, 2018. DOI: 10.1016/j.renene.2018.01.051
A. T. Mustafa, H. H. Al-Kayiem, S. I.U. Gilani, “A Review of the Vortex Engine”, WIT Transactions on Ecology and the Environment, Vol. 179, pp. 911-920, 2013. DOI: 10.2495/SC130772
A. T. Mustafa, H. H. Al-Kayiem, S. I.U. Gilani, “A Review of Convective and Artificial Vortices for Power Generation”, International Journal of Sustainable Development and Planning, Vol. 10, No. 5, pp. 650–665, 2015. DOI:10.2495/SDP-V10-N5-650-665
H. H. Al-Kayiem, A. T. Mustafa, S. I.U. Gilani, “Vortex field simulation and analysis of a solar updraft power engine”, WIT Transactions on Ecology and the Environment, Vol. 205, pp. 193-202, 2016. DOI:10.2495/EQ160181
Pritam Das and Chandramohan V.P., “Estimation of flow parameters and power potential of solar vortex engine (SVE) by varying its geometrical configurations: A numerical study”, Energy Conversion and Management, vol. 223, 113272, 2020. DOI: 10.1016/j.enconman.2020.113272
Abdullah A. Badr, Omer K. Ahmed, Omar Rafae Alomar, “Performance of solar vortex engine integrated with the PV panel: Experimental assessment”, Renewable Energy, Volume 216, 119073, 2023. DOI: 10.1016/j.renene.2023.119073
Hussain H. Al-Kayiem, Ali M. Tukkee, Syed I.U. Gilani, “Assessment of the design influence of the vortex generator on the performance of the solar vortex engine”, Energy Conversion and Management: X, vol. 16, 100283, 2022. DOI: 10.1016/j.ecmx.2022.100283
Ali M. Tukkee, Hussain H. Al-Kayiem, Syed I.U. Gilani, “Effect of density variation method and air humidity consideration on the computational simulation of solar vortex power generation systems”, Thermal Science and Engineering Progress, vol. 37, 101574, 2023. DOI: 10.1016/j.tsep.2022.101574
Downloads
Published
Issue
Section
License
Copyright (c) 2024 Ayad T. Altai
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
The authors retain the copyright of their manuscript by submitting the work to this journal, and all open access articles are distributed under the terms of the Creative Commons Attribution-NonCommercial 4.0 International (CC-BY-NC 4.0), which permits use for any non-commercial purpose, distribution, and reproduction in any medium, provided that the original work is properly cited.
