Experimental Analysis of Air Inlet Height Variation in a Solar Tower system Using Plate and Metal Foam Absorber
DOI:
https://doi.org/10.29194/NJES.25030120Keywords:
Tower Updraft System,, Inlet Air Height, Porous Media, Copper Foam, Renewable EnergyAbstract
The experimental analysis is conducted under the Iraqi climate conditions to investigate the performance enhancement of a solar updraft tower system (SUTS) using the porous copper foam as an absorber plate and conventional absorber plate with absorber inclination angle of 18°. In the present work, a semicircular collector is divided into two identical quarter thermal collectors to become two identical SUTS. One of the quarter circular thermal collectors contains on the metal foam as an absorber plate, while the other quarter collector on the conventional flat copper absorber plate. In this study the air inlet height is changed of (3, 5, and 8) cm. The experimental tests carried out in Baghdad city (latitude 33.3° N). Results showed that the air inlet height variation caused to enhance the solar updraft tower performance. The highest values was recorded when the air inlet height is 3 cm using porous absorber compared to flat absorber plate. Copper material foam as an endothermic surface causes a marked decrease in average surface temperature of the plate. The maximum hourly thermal efficiency of solar collector was increased to about 41.6 % and the maximum enhancement of the power output to about 45.2 % compared with flat absorber plate.
Downloads
References
Oztas F., Kal?pc? E. and Bozkurt E., ''How do biology teacher candidates perceive global climatic change,'' Energy Educ Sci Technol Part B, 3, 99–107, (2011).
Ucar A., ''The environmental impact of optimum insulation thickness for external walls and flat roofs of building in Turkey’s different degree-day regions,'' Energy Educ Sci Technol Part A, 24,49–69, (2009).
Balo F., ''Energy and economic analyses of insulated exterior walls for four different city in Turkey,'' Energy Educ Sci Technol Part A, 26,175–188, (2011).
Demirbas A., ''Concept of energy conversion in engineering education,'' Energy Educ Sci Technol Part B 1,183–197, (2009).
Kirtay E., ''The role of renewable energy sources in meeting Turkey’s electrical energy demand,'' Energy Educ Sci Thecnol Part A 23, 15-30, (2009).
Kecebas A. and Alkan M.A., ''Educational and consciousness-raising movements for renewable energy in Turkey,'' Energy Educ Sci Technol Part B 1,157–170, (2009).
Sahin Y., ''Environmental impacts of biofuels,'' Energy Educ Sci Technol Part A, 26,129–142, (2011).
Keskin A. and Emiroglu A.O., ''Catalytic reduction techniques for post-combustion diesel engine exhaust emissions,'' Energy Educ Sci Technol Part A, 25, 87–103, (2010).
Saidur R., ''Energy, economics and environmental analysis for chillers in office buildings,'' Energy Educ Sci Technol Part A, 25, 1–16, (2010).
Demirbas A., Social, economic, ''environmental and policy aspects of biofuels,'' Energy Educ Sci Technol Part B 2, 75–109, (2010).
Rajamohan P., Rajasekhar R.V.J. and Shanmugan S. and Ramanathan K., ''Energy and economic evaluation of fixed focus type solar parabolic concentrator for community cooking applications,'' Energy Educ Sci Technol Part A, 26,49–59, (2010).
Ralegaonkar R.V. and Gupta R., ''Application of passive solar architecture for intelligent building construction: A review,'' Energy Educ Sci Technol Part A 26, 75–85, (2010).
Al-Nimar M. K., Alkam M. k.,'' A Modified Tubeless Solar Collector Partially Filled with Porous Substrate,'' Renewable Energy, Vol. 13, No. 2, PP. 165-173, (1997).
Bashir Ahmed Danzomo, Sani Jibrin, Mohd. Maarof B Hj Abd Moksin, "Simulate Model Design and Performance Evaluation of Solar Tower System," ARPN Journal of Engineering and Applied Sciences, VOL. 7, NO. 4, (2012).
Chang Xu, Zhe Song, Lea-der Chen, Yuan Zhen, "Numerical investigation on porous media heat transfer in a solar tower receiver," Renewable Energy, Vol. 36, PP. 1138-1144,( 2011).
Abdel Hamid Boualit, Saleh Larbi, Amor Bouhdjar, ''Finite Element Analysis of Laminar Flow in Solar Chimney,'' Séminaire International sur le Génie Climatique et l’Energétique, SIGCLE, (2010).
Xinping Zhou, Theodor W. von Backström, Marco Aurélio dos Santos Bernardes, '' Introduction to the special issue on solar chimneys'', Huazhong University of Science and Technology, China, Solar Energy, Vol. 98, PP. 1- 98, (2013).
Dr. Sabah Tarik Ahmed, Miqdam Tariq Chaichan, ''A study of Free Convection in A solar Chimney Model'', Eng.& Tech. Journal ,Vol.29, No.14, (2011).
Abdulcelil BU?UTEK?N, ''AN Experimental Investigation of the Effect of Periphery Height and Ground Temperature Changes on the Solar Chimney System, ''J. of Thermal Science and Technology, Vol. 32, No. 1, PP. 51-58, (2012).
Mehrdad Ghalamchi, Alibakhsh Kasaeian, Mehran Ghalamchi, Alireza Hajiseyed Mirzahosseini, ''An experimental study on the thermal performance of a solar chimney,'' Renewable Energy, Vol. 91, PP. 477- 483, (2016).
Carl F. Kirstein, ''Flow through a Solar Chimney Power Plant Collector-to-Chimney Transition Section,'' Journal of Solar Energy Engineering (ASME), Vol. 128, PP. 312-317, (2006).
Bashir Ahmed Danzomo, Sani Jibrin and Mohd. Maarof B Hj Abd Moksin, "Similitude Model Design and Performance Evaluations of Solar Tower System", ARPN Journal of Engineering and Applied Sciences, Vol. 7, No. 4, (2012).
Haider Salim Nuri, ''Enhancement of Solar Chimney Performance by Using Geometrical and Thermal Energy Storage Techniques'', M.Sc. Thesis, Al-Mustansiriyah University, Iraq, (2014).
Aseel K. Shyaa, Rafea A. H. Albaldawi, Maryam Muayad Abbood, "Experimental and Numerical Study of Collector Geometry Effect on Solar Chimney Performance", Al-Khwarizmi Engineering Journal,Vol. 12, No. 4, P.P. 59- 71, (2016).
Mohammed A. Aurybi, Hussain H. Al-Kayeim, Syed I. U. Gilani and Ali A. Ismaeel, ''Mathematical Modeling to Evaluate the Performance Enhancement of Solar Updraft Power Plant by External Heat Source, " ARPN Journal of Engineering and Applied Sciences, Vol. 11, NO. 20, PPI. 12128- 12133, (2016).
Ali M. Ali, '' Enhancement of Heat Transfer in a Flat-Plate Solar Collector Inserted Metal Foam Blocks, M.S. Thesis, University of Baghdad, Iraq, (2017).
Mélanie Delort, Ali Hamada Fakra, B Malet-Damour, Jean Claude Gatina, "Measuring uncertainty assessment of an experimental device used to determine the thermo-optico-physical properties of translucent construction materials," Measurement Science and Technology, IOP Publishing, (2021).
Jörg Schlaich, Rudolf Bergermann, Wolfgang Schiel, Gerhard Weinrebe, "Design of Commercial Solar Updraft Tower Systems – Utilization of Solar Induced Convective Flows for Power Generation," Journal of Solar Energy Engineering (ASME), Vol. 127, No. 117, (2005).
Kasaeian A.B., Molana Sh., Rahmani K., Wen D., ''A review on solar chimney systems'', Renewable and Sustainable Energy Reviews, Vol. 67, PP. 954–987, (2017).
Maryam Muayad Abbood, ''Guide Vanes and Collector Geometry Effects on the Performance of Solar Chimney'', M.Sc. Thesis, Al-Mustansiriyah University, Iraq, (2016).
Downloads
Published
Issue
Section
License
Copyright (c) 2022 Sarmad A. Abdul Hussein, Mohammed A. Nima
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
The authors retain the copyright of their manuscript by submitting the work to this journal, and all open access articles are distributed under the terms of the Creative Commons Attribution-NonCommercial 4.0 International (CC-BY-NC 4.0), which permits use for any non-commercial purpose, distribution, and reproduction in any medium, provided that the original work is properly cited.
