×
The submission system is temporarily under maintenance. Please send your manuscripts to
Go to Editorial ManagerIn this vast world after an earthquake lessons are learned; many strategies have been considered in order to achieve a proper seismic strength capacity.The aim of this paper is studying the seismic behavior of a typical reinforced concrete bridge pier in Iraq and implementing a proper technique of strengthening in order to fix any damage that had happened.Structure of a full scale three-dimensional finite element model was used in order to simulate a reinforced concrete pier via the computer software ABAQUS/CAE 2017 using concrete plasticity damage model (CDP).Under the action of Halabja earthquake, which was recorded at city of Halabja in Iraq on 12 November 2017, the behavior of model was traced, analyzed and the resulted damages were managed.The finite element analysis results indicated that the proposed configuration of carbon fiber reinforced polymers laminates substantially increases the lateral load strength and deformation capacity of the bridge pier
CFDSST Concrete Filled Double-skinned steel tubular columns are composite columns consisting of two concentric circular steel tubes with concrete filler in between. Finite elements method is considered through the use of the computer program ABAQUS to model CFDSST columns numerically under cyclic axial compression. Damage plasticity model was considered to model the concrete while elastic-plastic model used to model the steel tubes. six CFDSST specimens and three ordinary Concrete Filled Steel Tubular (CFST) specimens were analyzed under static axial compression, while three CFDSST specimens were considered for analysis under cyclic axial compression. The numerical results were presented in terms of axial load axial strain displacement curves. It was found that the ultimate axial load carrying capacity calculated numerically in good agreement with that of the experimentally tested specimens. Also it was concluded that Damage plasticity model used for simulating the behavior of concrete and metal plasticity model used for simulating the behavior of steel produced accurate results as compared to the experimental results.
In this paper, a quick stop device technique and the streamline model were employed to study the chip formation in metal cutting. The behavior of chip deformation at the primary shear zone was described by this model. Orthogonal test of turning process over a workpiece of the 6061-T6 aluminum alloy at different cutting speeds was carried out. The results of the equivalent strain rate and cumulative plastic strain were used to describe the complexity of chip formation. Finite element analysis by ABAQUS/explicit package was also employed to verify the streamline model. Some behavior of formation and strain rate distribution differs from the experimental results, but the overall trend and maximum results are approximately close. In addition, the quick stop device technique is described in detail. Which could be used in other kinds of studies, such as the metallurgical observation.
This paper presents a numerical investigation to study the effect of variations in displacement history sequence and magnitude on cyclic response of RC tapered (haunched) beams (RCHBs).Five simply supported RCHBs (four haunched and one prismatic) were selected from experimental work carried out by Aranda et al. The selected variables included were five loading history types. The first part of this study focused to verify the finite element analysis with selected experimental work and the second part of this study focused too studying the effect of varying in loading history to the response of RCHBs. The finite element code Abaqus was used in the modeling. The adopted cyclic simulation performance of the selected beams using the plastic- damage model for concrete developed by Lubliner and Lee & Fenves. The constitutive model of plain concrete describing the uniaxial compression response under cyclic loading proposed by Thorenfeldt, and the uniaxial tension response follows the softening law proposed by Hordijk was used in the modeling. Menegotto-Pinto model was used to simulate the steel response. Model verification has shown A good agreement to the selected experimental work. The variations in loading history will decrease the ultimate load and corresponding deflection with increase in the number of cycles at ultimate load.