×
The submission system is temporarily under maintenance. Please send your manuscripts to
Go to Editorial ManagerThe present work is a numerical study of thermal performance of modified flat plate solar water collectors. Numerical simulations have been done by solving the governing equations (Continuity, Momentum and Energy) equations in the laminar regime , three dimensions by using the FLUENT software version (14.5). The effect of flow on temperature distribution of flat plate water collectors by inserting (twist strip with twist ratio (3), helical spring surrounding the solid shaft) inside riser pipes is numerically simulated and compared with solar collector without inserting device inside its riser pipes at flow rates of (100)?/h . The numerical simulation results show that the flat plate water, solar collectors with the inserted, twist strip and helical spring that’s surround the solid shaft were higher enhancement of heat transfer than without inserted devices. The useful energy in case of twist strip is (10%) higher than the case of flat plate solar collector without enhancement device. Also, the case of helical spring is increased (6.8 %) than the twist strip, and (16.2%) than collector without enhancement device for the same mass flow rate.
The 3-D numerical simulations of the thermal collectors in solar heating systems were conducted to simulate the conventional solar heating system, multipurpose solar water heater (MPSWH), and multipurpose solar air heater (MPSAH). The commercial computational fluid dynamics (CFD), AVL Fire ver. 2009.2 was used to solve and investigate the temperature distributions in the absorber plate and riser tube of both solar water and air heater during summer and winter seasons. The RNG k -turbulence model was employed for this CFD study. The present paper was to provide a good understanding of thermal performance for the solar collector at different operating conditions. The experimental setup and physical data of Venkatesh, R. and Christraj, W. [15] were employed as geometric parameters and initial boundary conditions to model and to validate the predicted numerical values. Comparing to the values of temperatures for the conventional SWH and SAH, the predicted results of the MPSWH and the MPSAH showed a good improvement on the thermal performance. These enhancements on the temperature may have been due to the new design adopted in the multipurpose solar heating systems by using riser tubes and headers to the original design of the thermal systems. Additionally, the thermal performance of solar collectors increases with increasing the mass flow rates and thermal conductivity of absorber plate. For validation aspect, the predicted results of all cases examined showed a good agreement against the measured results in terms of temperature distribution levels and thermal efficiencies.
The experimental analysis is conducted under the Iraqi climate conditions to investigate the performance enhancement of a solar updraft tower system (SUTS) using the porous copper foam as an absorber plate and conventional absorber plate with absorber inclination angle of 18°. In the present work, a semicircular collector is divided into two identical quarter thermal collectors to become two identical SUTS. One of the quarter circular thermal collectors contains on the metal foam as an absorber plate, while the other quarter collector on the conventional flat copper absorber plate. In this study the air inlet height is changed of (3, 5, and 8) cm. The experimental tests carried out in Baghdad city (latitude 33.3° N). Results showed that the air inlet height variation caused to enhance the solar updraft tower performance. The highest values was recorded when the air inlet height is 3 cm using porous absorber compared to flat absorber plate. Copper material foam as an endothermic surface causes a marked decrease in average surface temperature of the plate. The maximum hourly thermal efficiency of solar collector was increased to about 41.6 % and the maximum enhancement of the power output to about 45.2 % compared with flat absorber plate.