×
The submission system is temporarily under maintenance. Please send your manuscripts to
Go to Editorial ManagerTwo lasers were utilized for silicon processing using photoelectrochemical etching and laser texturing in order to produce nano/micro structures, respectively. Photoelectrochemical etching process utilizes a CW diode laser of 532 nm wavelength was used to support electrochemical etching for both n-type and p-type conductivity. While laser texturing process was employed using pulsed fiber laser of 1064 nm wavelength. Various characterization methods were devoted to examine silicon micro/nanostructures surfaces produced by lasers. These methods include AFM, SEM and Raman scattering to provide clear evidence about formation of micro/nanostructures abundant at silicon surfaces. Moreover, FTIR analysis for the laser produced silicon surfaces could emphasize whether the resultant silicon surface is hydrophilic or hydrophobic. Image analysis software adopted a side view micro image was used to measure the contact angle between the water droplet and silicon micro/nano-surfaces. It is found that the laser produced silicon nanostructure by photoelectrochemical etching creates a hydrophobic surface and even super hydrophobic with contact angle of 130 degrees for 50 nm average size. In addition, utilizing fiber laser of high repetition rate for laser texturing produces microstructures that are super hydrophilic with contact angle could reach 8 degrees for a surface dimension of 50 μm.
Biodegradable polymers are very useful polymers in biomedical applications. In this research, several hydrogels were fabricated by using two polymers, Polyvinyl alcohol (PVA) and Chitosan (Chs) by the solvent casting method in order to use them for skin applications. Several tests were carried out on these membranes such as Agar diffusion method to examine their antimicrobial activities, Fourier transform infrared microscopy (FTIR) test to study the differences in their chemical structures. Uniaxial tensile test was performed to examine the mechanical characteristics of these membranes. In addition, the wettability test was used to investigate the hydrophobicity or hydrophilicity of the surfaces. The results showed that all membranes are hydrophilic, of which the contact angles are less than 90°. The membrane manufactured from 75:25 Chs-PVA is more hydrophobic (contact angle is 74°) than other membranes made of 50:50 Chs-PVA and 25:75 Chs-PVA as the contact angles were 59° and 61°, respectively. The tensile test results indicate that the membrane fabricated of the PVA and the membrane that was fabricated by 75% Chs and 25% PVA has the highest tensile strength of 17.9 MPa, 16.2 MPa and Young^’ s Modulus of 181.2 MPa and 7.18 MPa, respectively. The highest strain at break was observed by the membrane of 25:75 Chs-PVA which equals to 24.67%. Chitosan membranes showed inhibition zones of about 2.99 cm and 2.75 cm in length, and 75:25 Chs-PVA membranes showed 5.1 and 5.91 cm in length for E.coli. To sum up, this copolymer is considered as promising hydrogel for skin applications such as wound dressing.